DSCN2915

Here's the grommet mod I mentioned earlier, it may look a little messy right now but it will be cleaned up later. I took one of the spare patches that FFR provided, cut 2" in the center and riveted the top portion to hold it on permanently, on the bottom was just held by sealant. Not alot of stress in this area, so I did not see any reason why to install more rivets. If you are wondering how I installed it without cutting wires. No I did not use a hacksaw or saw saw, I actually used a utility knife to cut the metal to a deep grooveand bennt the cut area back and forth afew times to break away. Then twisted the metal to fit around the wires. Once over the grommet, I twisted it back to shape and the rivets and sealant did the rest.